Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob has stopped working one day, it could be due to a dead coin battery or water damage the receiver module or a damaged electronic chip. These are all easy solutions that will bring your car back to speed in no time!
Car keys can also fail due to the blade getting worn. You can fix this issue by visiting your local Car Key Man Auto Locksmith to get a new blade installed.
Battery
The key fob in your Peugeot 308 may die or become weak enough to not send a strong signal. This can cause the key fob to stop functioning, preventing you from locking and opening the doors, or even starting your engine. You'll need a new battery on your key fob to correct this.
You'll need to buy a replacement battery from an auto parts store or your local hardware store. When you purchase the battery, make sure that it's brand new and hasn't sat on the shelf for a long time. A new battery has greater capacity and can send a stronger signal your car.
After replacing the battery If you have a new battery, try unlocking and locking the doors of your Peugeot by using the key fob. If the doors don't open, it's likely that the receiver module inside the car is at fault. Your local Peugeot dealer can reprogramme the receiver module.
It's possible that the chip inside your key fob has been damaged. It's possible to harm your key fob if you drop it on the ground or expose it to moisture. The rubber seals that shield the chip from moisture might wear down over time, especially if your key ring is exposed to water for prolonged periods of time, such as submerging it in the ocean at the beach. To avoid peugeot replacement key from happening, it's essential to keep your key fob safe from moisture and not let it come into contact with water.
Water Damage
Don't give up on your key fob if it gets wet, no matter if you slipped into a pool or fumbled into a pool. The key fob is protected by rubber seals however, prolonged exposure to water could damage its electronic chip. Since water is a good conductor, any water that makes it inside the key fob could cause a series of short circuits that eventually ruin the chip. After removing the battery scrub its contacts with isopropyl Alcohol and dry it completely before putting it back into.
A dead battery might be the reason that your Peugeot 308 won't start. If you have a spare vehicle, jumper cables can be used to get the engine running again. If you suspect that the battery is at fault then it must be replaced.
A defective receiver in your car can also prevent it from receiving the signal from the key fob. It could be due to a issue with the antenna or wiring, or the key fob may be damaged. It may be necessary to program a new fob into your vehicle if using one. If you are unable solve the issue, you should contact a professional technician. A technician trained in the field will be able detect the issue quickly and fix the issue immediately.
Radio Interference
Interference can result in symptoms such as a key fob that isn't recognized or has a limited range. It is either radiated or conducted, with the former being caused by power supply cables and speakers wiring that are too close to electrical components. In general, rerouting cables or moving them away from these components can solve the problem.
It's unlikely that someone is watching the signals from your key fob to steal your car, however it is possible that the signal is being distorted by radio frequency interference. Luckily, this is a simple issue to repair.
If you're experiencing a problem with your key fobs that aren't recognized, try a fresh battery. Make sure the battery is the right size and type. Incorrectly sized batteries can damage the fob.
These devices could interfere with the key signal, if they utilize the same radio frequency. Beware of attaching these devices to your key fob.
Pairing Issues
A car's remote keyless entry system contains a receiver that receives radio frequency signals from the key fob. If this receiver has developed issues, you will not be in a position to start your car even if the key fob is working and is modified. The issue could be caused by a range of causes, including the battery of a coin that is dead and water damage. The receiver could also be malfunctioning as a result of an error in the software or internal damage to the key itself.
The battery that powers your Peugeot 308 keyfob may have been drained. This battery can be replaced, however you must be sure it's the correct battery for your key fob. It is best to choose a battery that is the same size in terms of voltage, size, and specifications as the original.
Another reason why the reason why your Peugeot 308 key fob might not be working is due to the fact that it has been paired to another vehicle. You might have accidentally given the key fob to a friend or the key was used to unlock other vehicles. You can fix this by reprogramming your key fob with an OBDII scanner. This tool typically asks you to provide certain details regarding your vehicle, such as the VIN or engine type, so it's essential to fill in the correct information.